Welcome to Signmax.us Forum
WinPCSIGN BASIC - PRO Welcome to Signmax.us Forum
Author Message

<  Vinyl Cutter sign making   ~  Cuts are not clean

Pete
Posted: Wed Jan 25, 2006 3:20 am Reply with quote
Guest
I have a Vinyl Master Plotter When cutting graphics all is well.... But when I have to do small letters about 1 inch in size the cuts are not clean meaning when you weed it you can see on the letters themselves where the needle started abd stoped
I am wondering if the offset has anything to do with this? I changed the blade and it still is doing this Why in the Heck are the cuts not coming out clean? It is cutting at 800mms and about 25psi I have raised and lowerd the psi and still no clean cuts. Anyone have tips??? Oh yeah I am using 45 degree blades and cutting on Regular calenderd vinyl...
Pierre
Posted: Wed Jan 25, 2006 3:22 am Reply with quote
Guest
1-Check the offset you use in your software
2-Use low speed for small letter
3-if you use WinPCSIGN use the orientation blade in the cutting control panel and make sur the offset is between 10 to 14

if you don't solve the problem

1-Check your blade holder and knife
2-Change your Protection blade

Display posts from previous:  

All times are GMT
Page 1 of 1
Post new topic

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum